FB Technik
Filtern
Dokumenttyp
Volltext vorhanden
- ja (14)
Gehört zur Bibliographie
- nein (14) (entfernen)
Schlagworte
- Elektrode (2)
- Flüssigkristalline Polymere (2)
- Parkinson-Krankheit (2)
- Rauigkeit (2)
- electrode model (2)
- surface roughness (2)
- Algorithmus (1)
- Astrozyt (1)
- BEV (1)
- Bewegung (1)
Institut
- FB Technik (14)
For the assessment of human reaction time, a test environment was developed. This system consists of an embedded device with organic light-emitting diode (OLED) displays with push buttons for the combined presentation of visual stimulation and registration of the haptic human reaction. The test leader can define the test sequence with the aid of a graphical user interface (GUI) on a personal computer (PC). The validation of the system was proved by measuring the latency times of the whole system, which are conditioned by the specific hard- and software constellation. Through the investigation of the display’s light radiation by a photodiode and the recorded current consumption, latency times and their variance were specified. In the fastest mode the system can reach an error limit of 60 μs.
Electrical stimulation is used for example to treat neuronal disorders and depression with deep brain stimulation or transcranial electrical stimulation. Depending on the application, different electrodes are used and thus different electrical characteristics exist, which have to be handled by the stimulator. Without a measuring device the user would have to rely on the stimulator being able to deliver the needed stimulation signal. Therefore, the objective of this paper is to present a method to increase the level of confidence with characterization and modelling of the electrical behavior by using the example of one channel of our stimulation device for experimental use. In several simulation studies with an electrode model with values in a typical range for cortical applications the influence of the load onto the stimulator and the possibility to pre-estimate measuring signals in complex networks are shown.
The photo-Dember effect is a source of impulsive THz emission following femtosecond pulsed optical excitation. This emission results from the ultrafast spatial separation of electron-hole pairs in strong carrier gradients due to their different diffusion coefficients. The associated time dependent polarization is oriented perpendicular to the excited surface which is inaptly for efficient out coupling of THz radiation. We propose a scheme for generating strong carrier gradients parallel to the excited surface. The resulting photo-Dember currents are oriented in the same direction and emit THz radiation into the favorable direction perpendicular to the surface. This effect is demonstrated for GaAs and In(0.53)Ga(0.47)As. Surprisingly the photo-Dember THz emitters provide higher bandwidth than photoconductive emitters. Multiplexing of phase coherent photo-Dember currents by periodically tailoring the photoexcited spatial carrier distribution gives rise to a strongly enhanced THz emission, which reaches electric field amplitudes comparable to a high-efficiency externally biased photoconductive emitter.
Organic semiconductor distributed feedback laser fabricated by direct laser interference ablation
(2007)
We use a pulsed, frequency tripled picosecond Nd:YAG laser for holographic ablation to pattern a surface relief grating into an organic semiconductor guest-host system. The resulting second order distributed feedback lasers exhibit laser action with laser thresholds being comparable to those obtained with resonators structured by standard lithographic techniques. The details of the interference ablation of tris-(8-hydroxyquinoline) aluminum (Alq(3)) doped with the laser dye 4- dicyanomethylene-2-methyl-6-(p-dimethylaminostyryl)-4H-pyran (DCM) are presented and discussed. Lasing action is demonstrated at a wavelength of 646.6 nm, exploiting second order Bragg reflection in a relief grating with a period of 399 nm.